Sega ST-V Multi-Cart Housing

  • Click to enlarge
  • Click to enlarge
  • Click to enlarge
  • Click to enlarge
  • Click to enlarge
Sega ST-V Multi-Cart Housing

Tap for gallery

$32.45 $24.73


Product Information
Specification

A 3D Printed cartridge housing for use with Darksoft's ST-V Multi-Cart. Printed in a silver PLA material with a design that is not only a bit more sleek than the original cartridges but also offers a much more secure fitment of the cartridge within the housing and seats much more securely into the ST-V main board. Opens along the top are available for access to the SD-Card slot as well as the jumper pins, with an opening wide enough to accomodate a ribbon cable connection for a remote game selector. There is also an opening along the side allowing for wires to pass through for the reset wire as well as the wire for the loading sound. For easy disconnection a header can be soldered to the side:  1 | 2 | 3.

Includes the front and back housing as well as 2 screws to secure them together. DOES NOT INCLUDE the ST-V Multi Cart.

This Cart Housing will only fit Multi-Carts with the 90 degree header. It has come to our attention that a handful of early ST-V carts were modified to replace the 90 degree game selection header at the top of the cart with a straight through shrouded header. This cart housing was designed to be used with the 90 degree header, as a straight through shrouded header will not allow a ribbon cable to fit under the housing. If you wish to use this cart and you have a shrouded header, then you'll need to swap it out for a 90 degree header.

Product Code STVMCARTHOUS
Manufacturer bit_district
Stock Level 3
Condition New
Weight 0.1560lb

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

Verify you are a human

Please enter a valid email address.
This field is required.
Top

eCommerce by CubeCart